Contact
support@ohptools.com

Blog

RSS Blog Feed

How to Configure the BMW ENET Cable for ISTA

21 Mar, 2022

How to Configure the BMW ENET Cable for ISTA

Configuring the correct settings of the ENET cable is a crucial process when dealing with any BMW coding and programming software, such as ISTA. In this post, we’re going to show you the steps on how to properly set up the ENET cable when using the ISTA BMW software.
Read article
How to Program and Code a Newly Installed Tail Light on a BMW with ISTA

19 Feb, 2022

How to Program and Code a Newly Installed Tail Light on a BMW with ISTA

Installing a new tail light on your BMW can be quite tricky sometimes due to some compatibility issues with your new parts and your vehicle model. Oftentimes, the process requires programming or coding to make sure that the system in your vehicle is in-sync with your newly installed tail light. This can be done with the use of programming and coding software such as ISTA. 
Read article
How to Program and Code your BMW with ISTA/P

17 Sep, 2020

How to Program and Code your BMW with ISTA/P

ISTA/P stands for Integrated Service Technical Application/Programming. It is a dealer-level diagnostic software that replaced the older version SSS Progman programming software. ISTA/P is primarily used for processing all coded, programmed, and enable-dependent control modules of BMW vehicles.
Read article